EDA Plastic pressure compensation plug

The pressure compensation plug equalises the pressure that occurs, due to temperature differences, inside the enclosure with the outside environment, while reducing the risk of dust entering the enclosure.

CE Declaration of Conformity
EDA Product Image
EDA Catalogue drawing image
  • Список товаров
  • Accessories
  • Технические данные
  • Характеристики
  • Загрузки
  • Сертификаты

Список товаров

Номер товара Описание
EDA40 Pressure compensation plug
Range Mandatory Accessories Related Accessories Similar accessories Описание
EDAS - - This stainless steel pressure compensation plug equalises the pressure inside the enclosure, at low risk of water condensation and dust entering the enclosure, and maintains IP66.
DWP - - Drain plug to remove condensation water to maintain IP 44.
PVD - - This plastic pressure compensation plug equalises the pressure inside the enclosure, at low risk of water condensation and dust entering the enclosure, and maintains IP55.

Технические данные

Description:

It compensates the pressure with high IP. In the enclosures pressure differentials can occur during extreme temperature variations, when this happens there is risk of dust and humidity inside the enclosure. Even with a slight overpressure, a waterproof membrane inside the plug allows air and humidity to leave the enclosure. In the opposite direction, it only allows dry air into the enclosure. Mounting with thread M40x1.5 with nut, recommended torque of 5 Nm (max. 10 Nm). For optimal pressure compensation we recommend to use two devices on opposite sides towards the top of the enclosure. Air permeability of 1200 l/h at a pressure difference of min. 70 mbar.

Material:

Plastic. Sealing gasket NBR.

Operating temperature:

-35 °C to +70 °C.

Machining required:

Round hole 40.5 mm diameter. Depth in the enclosure of approximately 16 mm.

Protection:

IP 66 / IP X9K.

Approvals:

CE.

Finish:

Light grey.

Pack quantity:

1 piece.

Характеристики

Feature:

Plastic pressure compensation plug with waterproof membrane.

Advantage:

In certain locations there can be wide temperature variations especially over a short period of time, which creates pressure differences from the inside to the outside of the enclosure. The pressure plug equalises the pressure inside and outside the enclosure allowing air and humidity to leave, while only allowing dry air to enter inside the enclosure. The plug can be easily installed and only requires a round hole to be machined .

Benefit:

The pressure compensation plug reduces the risk of dust entering the enclosure, ensuring that a vacuum is not created. Built up humidity can leave the enclosure which reduces potential hazards with electrical components. The ease of installation reduces the labour time required and means that the modification can be done on site while the enclosure is operational, saving unnecessary downtime.

Comment:

It is highly recommended to install two plugs per enclosure for optimal pressure compensation. The plugs should be installed both at the top of the enclosure but on opposite sides. If a more cost effective solution is required then the pressure plug, PVD, should be used which will reduce the protection degree to IP55

Mounting instructions document (PDF) Thermal Management EDA 143 KB
Рисунок (JPG 800 x 518 px) EDA Catalogue drawing image 56 KB
Рисунок (JPG 600 x 600 px) EDA Product Image 71 KB
Список изделий (PDF) EDA(RUSSIAN) 60 KB
Document (PDF) CE Declaration of Conformity 58 KB